IMSAI -
FDC Boards
Like MITS/Altair at the time the IMSAI Floppy disk controller was spread
over two boards. This was a time before the Western Digital 1771/1791 LSI
FDC chip was available and such boards had to be made from simple 7400 type
chips. These boards were designed to work with 8" IBM single density format
on Calcomp floppy drives only. Unfortunately these drives were notoriously
unreliable. There was a later controller (the DIO/PDS controller) that was
used to work with 8" PerSci drives (and later more reliable 8" and 5"
drives), single and double density.
The two boards were called the "FIF". The FIF
board was an interface/controller consisting of an IFM (Interface Master Board)
and a FIB (Floppy Disk Interface board) which interfaced the disk to the
computer. The combination of FIB and IFM boards created an intelligent
controller with DMA transfer capability which permitted the computer to perform
other tasks during disk operations. The IFM board used its own 8080A processor
which was programmed to support the floppy disk system. The program was stored
in 1K onboard byte EPROM chips and could be changed to support different data
formats and densities on the floppy disk drives.
Included with the boards was a disk bootstrap capability that reads and
executes the contents of the first disk sector, allowing the disk operating
system to gain control after turning on the computer. A single FIF interface
will control up to four disk drives in a daisy chain signal bus, and could
write-protect drives under software control. Commands included Read Clock and
Data Bits, Write Sector, Read Sector, Verify Sector, Format Track, Write Deleted
Data Sector Mark, Write Protect, Write Enable and Restore Drive.
Logical and physical track addresses may be different. Cyclic redundancy checks
were performed automatically. When an error was detected in reading or writing,
the logic automatically retried up to 10 times. The FIF board was furnished with
a cable to connect the board to the rear of the computer chassis and a
second cable to connect the chassis to the Floppy Disk Drive cabinet.
connected to each other and to a dual drive cabinet shown below.
I have not yet located a manual for this board set. If you have one
please let me know.
IMSAI S-100 Boards
4KRAM
8080CPU
EPROM-Programmer
MPU-B
PIC-8 PIO
PROM-4 SIO
VIO
MIO
FDC (FIB/FIM)
This page was last modified
on
01/08/2011